Home › Forums › Help/Technical Questions › FAQ: My pedal needs repaired and is still under warranty. What do I do?

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • June 4, 2009 at 3:29 pm #78347
    The EH Man
    Moderator

    If you have a broken EHX pedal still under warranty, you can send it to EHX for repair.

    Contact EHX here for warranty repair info: info@ehx.com

    If your pedal is no longer under warranty, they may still be able to fix it for a fee.

    March 31, 2010 at 8:49 am #108936
    Azagaroth
    Participant

    hi,

    i got an old graphic equalizer. its not working aymore and there is no waranty anymore.
    is it possible for me to get a circuit diagram from you, so that i can try to fix it myselve or what should i do?

    Thanks in advance

    there is picture of the eq attached

    May 15, 2010 at 1:29 pm #102704
    maibanez
    Member

    I have a #1echo, it don’t work anymore, check the power and it work fine, i take the pedal out of my board and wen the pedal is of i have sound from my amp, but wen is of no….. the light is on but no sound

    i not have warranty and I have a little bit of knowledge of electronics

    what can i do?
    what could be?

    October 11, 2011 at 12:30 am #116125
    modalmood
    Member

    Is the warranty transferable for a pedal (Holy Grail Nano) purchased on Ebay? It was originally bought on 9/16/11. I have the original sales receipt. Thanks very much.

    Mike

    April 21, 2013 at 6:21 pm #118953
    doddoda
    Member

    I have a problem with “hot tubes overdrive” of you which i used to use a lot.
    it appears that the inner torodial power transformer from 10v to 220v (“Taiwan torodial technology inc.”)
    , outputs a low output of 60v, and the pedal gives a very low volume and strange cut sound.
    I turned to a few technician here (israel), and even tried contacting “Taiwan torodial technology inc.”, and I have no info about where I can get this part.

    November 15, 2020 at 3:33 pm #126611
    Francisco Machuca
    Member

    Hi,
    I have an issue with my ehx freeze.
    Red light blinks all the time. It does not respond when the switch is pressed. The power supply is the original. I have tried other power supplies and the problem persists. I’ve checked the switch and it’s fine, I’ve even tried another switch and it doesn’t seem like that’s the problem. The toggle switch that selects fast, slow and lacth modes works properly but the only way to stop the light blink is by disconnecting the power supply. There is no waranty anymore
    Thanks in advance.

    November 15, 2020 at 9:36 pm #126612
    EHX STAFF
    Keymaster

    Please write the service techs on Monday at

    info@ehx.com

  • Author
    Posts
Viewing 7 posts - 1 through 7 (of 7 total)
  • You must be logged in to reply to this topic.