Home › Forums › Help/Technical Questions › dual loops on the stereo memory man

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • April 21, 2011 at 8:53 pm #81566
    allmektig
    Participant

    I read in the user manual for the smmh that if I had something plugged into both inputs and both outputs, it would threat both signals as seperate.

    So I was thinking that I could plug my sound source into input a, then plug output a into input b, and output b to my next effect pedal.

    I just wanted to make sure that doing that wouldn’t break anything.

    Are there any complications that can arise from running the same signal two times trough the SMMH like that?

    April 22, 2011 at 1:42 pm #115071
    Cryabetes
    Participant

    i think feedbacks go further when you do that. also there might be some crosstalk, but otherwise you’re effectively doubling the delay time.

    I know with a lot of stereo chorus pedals, you can loop one output back into the input and use the rate and feedback knobs as a monophonic oscillator. sounds like something you might be into.

    April 22, 2011 at 3:47 pm #115072
    EHX STAFF
    Keymaster

    Check it out.

    http://www.ehx.com/blog/ehx-tone-tips-stereo-memory-man-w-hazarai

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.