Home › Forums › Help/Technical Questions › B9 and initial power up issue

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • December 9, 2015 at 2:34 pm #84183
    gennation
    Member

    I have this issue with just about any power brick I use: a BBE Supacharger, Voodoo Lab 2+, and a (since sold) joyo 2.

    I have a weird thing with my B9…the B9 won’t produce sound when engaged after initially powering my board up. It has power to it, it passes sound when disengaged, but no sound comes from it when engaged. I have a workaround though, I pull the power plug from it, plug it back in, then fiddle around with the knobs/faceplate a bit and it comes to life. I can find no sequence of getting it to fire up except to mess with the knobs a bit. Strange…

    but even stranger, if I run it off the EHX supply that came with it, it works flawlessly at start up everytime.

    Can’t figure it out. Any thoughts? Common thing, defective pedal, better work around, etc…?

    December 9, 2015 at 6:25 pm #121078
    EHX STAFF
    Keymaster

    The B9 is designed for use with the supply included with the pedal.
    We have no control over other companies power supply.
    Use the original.

    February 21, 2016 at 3:06 pm #121284
    mbp06
    Member

    Hi,

    I have quite the same issue with B9, although I am powering it only with EHX Power Supply.

    Sometimes it works, sometimes not. When it is not working : the signal goes through the pedal with a little distortion and when I engage the pedal : NO SOUND.

    Even if I try to touch the button etc…it stays like this : not working.
    After that I let the pedal off some days without power…and sometimes it works again normally

    Please explain and help me.

    Best regards

    Ryan from France

    February 24, 2016 at 2:49 am #121297
    EHX STAFF
    Keymaster

    Please write service at info@ehx.com

    They can help you.

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.