- This topic has 3 replies, 3 voices, and was last updated 1 year, 10 months ago by .
Viewing 4 posts - 1 through 4 (of 4 total)
Viewing 4 posts - 1 through 4 (of 4 total)
- You must be logged in to reply to this topic.
Home › Forums › Help/Technical Questions › Super Switcher 4 Cable Method Help
I’ve tried searching for this answer everywhere…but in the event that I missed a thread please direct them there.
So my question is this:
I am aware that there is the effects send/return between loops 5 and 6 which you can route to the back of your amp. BUT it seems like this is for effects that are “always on” and therefore not meant to be changed/selected.
What I would like to do is have several effect pedals running through the back of my amp (reverb, delay etc) that I can select (as opposed to always on) and that would be selectable via the Super Switcher. Is there anyway to do this?
Bump, hope someone can give me some insight on this
Bump. Need to know if this is possible before I’ll buy it
Yes, you can do this. What you do is route the Super Switcher’s always on loop, located between 5 and 6, to your amp’s Input and FX Send jacks. Then you place the pedals that would normally go into your effects loop, such as delay and reverb, into the Super Switcher’s loop numbers 6, 7, 8. The output of the Super Switcher is then connected to the amp’s FX Return jack. So, the Super Switcher’s loops 6, 7, 8 are now in your amp’s FX loop but you can turn them on/off with the Super Switcher.
Here’s a potential signal chain with sample effects:
Super Switcher SND -> Amp’s Input -> Amp’s FX Send -> Super Switcher RTN
Super Switcher Ch 6 SND/RTN -> Delay
Super Switcher Ch 7 SND/RTN L -> Reverb
Super Switcher Ch 8 SND L/RTN L -> Tremolo
Super Switcher OUT L -> Amp’s FX Return