I have a MacBook M1 pro with Ventura 13.0, and I have to run the old 1.0 version of the app.
If I use the latest version 1.0.49, my Macbook won’t connect to the 1440, and so I can’t export manage the loops on the 1440, or ever run the firmware update!

Would it be possible to assign a different function to the Stop (fx) switch for each loop slot?

I’d like to be able to assign the stop, rev/oct, or trigger function depending on the the nature of a loop.

Can you update the manual?
these PC message are not reported in the Midi Mapping!!!

a. PC 71 – Play function: always initiates the PLAY function unless the loop is empty. As long as audio is found in the currently selected loop bank, and no matter the current mode, sending PC71 will put the 1440 into play mode. PC71 does not start an overdub, record, or stop playback.

b. PC 72 – Record/Dub function: always initiates the REC or OVERDUB function. 1440 will choose the correct function based on the current state. On an empty loop, PC 72 starts a recording. PC 72 starts an overdub on a playing loop, or immediately starts overdub/play on a stopped loop. During a new recording, PC 72 will close the loop and put the 1440 into overdub.

c. PC 128 – Direct Loop Erase. Immediately erases the loop of the currently selected loop bank, with no extra confirmation. The loop must be stopped for PC 128 to work. Caution! Once the loop is erased, it is gone forever, this function cannot be undone.

Thank you!!!