Clipping and distortion with Grand Canyon
Post Reply
Newbie
Rank
Total Posts:  2
Joined  2019-03-16
Posted: 16 March 2019 04:49 PM

Anyone encountered this? In shimmer mode, if I have delay level past 12 I get bad clipping, like it’s pushing the speaker too hard. I isolated fhe pedal to rule out other offenders and tried it through an amp with plenty of headroom, studio headphones and bookshelf monitors. Not running any overdrive or anything just clean guitar into shimmer and it clips in the mid to low end it sounds like.

Any ideas?

Quote
Administrator
RankRankRankRank
Total Posts:  1287
Joined  2011-02-22
Posted: 16 March 2019 05:09 PM | Link to this reply (#1)

Should not do that.
What if you reduce signal to the unit??

Quote
Administrator
RankRankRankRank
Total Posts:  1287
Joined  2011-02-22
Posted: 16 March 2019 05:09 PM | Link to this reply (#2)

Can you record what it sounds like?

Quote
Newbie
Rank
Total Posts:  2
Joined  2019-03-16
Posted: 16 March 2019 05:10 PM | Link to this reply (#3)

Thanks for the quick response. I tried with guitar direct in and same result. It’s all in the effects loop normally so signal should be pretty low

Quote
Administrator
RankRankRankRank
Total Posts:  1287
Joined  2011-02-22
Posted: 16 March 2019 05:38 PM | Link to this reply (#4)

If you tried it outside the effects loop (which could the issue)EX straight guitar in and out to a clean amp input on the front and and you hear it clipping something is off.
If the other modes are fine I have NO idea.
Please contact the techs Monday at
.(JavaScript must be enabled to view this email address)

Quote
 
Post Reply
 
RSS 2.0 Atom Feed